Happy Father's Day

Here is the card I made for my husband.  I found the Tutorial on the Paper Craft Planet website. Start with a 4 x 4 piece of DSP; Fold in half so that you end up with a triangle shape; Open triangle up and use the center crease as a guide. Fold pointed end of DSP to center crease. Repeat with other side and turn over. Your project should resemble a cone. Take the top end (small folded tip) and fold down about 1/2 of the way down; crease, take the point and fold back up... not all the way back to the top... leave about 1/16 of an inch. Your project should look like a cobra snake getting ready to attack. On the section where the point meets the edge, fold again. Turn project over again and fold each side in to meet the center. Tie is complete. For the shirt: 5 1/2 x 4 1/4 inch card stock; fold top down about 1-inch; open back up. Cut slit in on the fold on each side leaving about 1 1/2 inches uncut in the center. To make the collar, fold side flaps down, secure with glue dots, add brads and the tie. Attached to front of your card.